Mesh/grid?

[aleksandr]

Hi,

is it possible to make a mesh/grid in SE ST2 in .prt on .psm? =)

Thx, alex

 

[Solid DNA]

Hi,

is it possible to make a mesh/grid in SE ST2 in .prt on .psm? =)

Thx, alex

By mesh grid did you mean have somehing in the sketch to help you place element?

In sketch mode, inside the Ribbon under the Home tab, draw group.

Look for Grid option ( a small grid with a pen) on the right end side of the group.

 

[aleksandr]

By mesh grid did you mean have somehing in the sketch to help you place element?

In sketch mode, inside the Ribbon under the Home tab, draw group.

Look for Grid option ( a small grid with a pen) on the right end side of the group.

Hi,
thank you for your answer but this is not what i was looking for.
I was looking for something like this: http://www.bombayharbor.com/productImage/0095071001227259954/Chain_Link_Fence.jpg

 

[Solid DNA]

Hi Sorry for the long delay

Yes it would be possible, but would not recommend in 3D (this would be too much work for the result.)

Create a face style, then apply this face style to a face.

Send you something by email