Need Help correcting Error Message

[ben alba]

I have attached several files needed, concerning an annoying error message that states that I must delete "dangling sketch entities".
I would appreciate your help in pointing out exactly where I need to go in the design tree, and what sequence I must follow, to do what I need to do to eliminate this error message.
For some reason, the help file in SWX 2006 is very unclear to me, on this matter.

Thank you,
Ben Alba

[email protected]

 

[jfdurnan]

I have attached several files needed, concerning an annoying error message that states that I must delete "dangling sketch entities".
I would appreciate your help in pointing out exactly where I need to go in the design tree, and what sequence I must follow, to do what I need to do to eliminate this error message.
For some reason, the help file in SWX 2006 is very unclear to me, on this matter.

Thank you,
Ben Alba

[email protected]

Ben

Edit Sketch - Sketch1 of Cut-Extrude1
Display/Delete Relations - Dangling relations are highlighted in colour. Select these and press Delete.
Redefine relation by selecting the end point of the arc and the connecting edge of the part Foot 2 (do this twice - once for each end point).

Please see attachment.

John
[email protected]