Good morning to everybody,
I'm a new user of solidworks and a new member of this forum.
I'm looking for information on how to generate a part list from an assembly
that has been saved as part. There alre lots of bodies and I would like to
use this bodies to generate a part list. Is it possible?
I was a SolidEdge user, and in SE a I was able to explode a 2d drawwing view
and modify it manually. Can it be done in SW?
I would appreciate if can re-direct to any answer if this question was previously posted.
Sincerely
Giovanni Pengue
I'm a new user of solidworks and a new member of this forum.
I'm looking for information on how to generate a part list from an assembly
that has been saved as part. There alre lots of bodies and I would like to
use this bodies to generate a part list. Is it possible?
I was a SolidEdge user, and in SE a I was able to explode a 2d drawwing view
and modify it manually. Can it be done in SW?
I would appreciate if can re-direct to any answer if this question was previously posted.
Sincerely
Giovanni Pengue