Continue to Site

Welcome to 3DCADForums

Join our CAD community forums where over 25,000 users interact to solve day to day problems and share ideas. We encourage you to visit, invite you to participate and look forward to your input and opinions. Acrobat 3D, AutoCAD, Catia, Inventor, IronCAD, Creo, Pro/ENGINEER, Solid Edge, SolidWorks, and others.

Problem with Sweep Command

Sanam

New member
Hi,
I want to use Explicit/With two guide curves of sweep command, but after selecting the profile and two guide curves the swept surface doesn't start and end at the start and end points respectively.
Thanks for your time and consideration
Yours faithfully
4545.JPG
 
I often see this situation when the driving geometry is too short; maybe the guide curves or the spine curve is not long enough? But I see that CATIA chose Curve.7 as the spine, which is what I suspect is causing the swept surface to be short. If the end planes are parallel, change the spine to a line (or axis) that is perpendicular to the planes.
 
Last edited:

Articles From 3DCAD World

Sponsor

Back
Top