SolidEdge In .NET

[shekhare]

Hi I am writing .Net dll for SolidEdge and I have very specific questions
1. There is no Cocreate Interface for .Net in SE is there any way around to start the instance of SE(SolidEdge).
2. I am able to create SE by latebinding method but I want it by early binding.
3. If I am traversing asembly and getting ocuurences how should I verify that a occurence is Part or Assembly?

Thanks in advance for any help

Shekhar

 

[support]

Checking into it...

» Hi I am writing .Net dll for SolidEdge and I have very specific questions
» 1. There is no Cocreate Interface for .Net in SE is there any way around
» to start the instance of SE(SolidEdge).
» 2. I am able to create SE by latebinding method but I want it by early
» binding.
» 3. If I am traversing asembly and getting ocuurences how should I verify
» that a occurence is Part or Assembly?
»
» Thanks in advance for any help
»
» Shekhar


Hello shekhare,

We are forwarding your question to the UG/Solid Edge folks down in Huntsville, Al. We know a few Application Engineers that may be able to help or at least point you in the right direction.

We'll post the reply ASAP.

Thanks for using the Q&A Board! ;-)

3DCADTips.com Q&A Board Support

 

[William B]

Hi all you CADs,

I would like to get more info on .NET issues too, similar to the original post.
Does anyone have an updated answer to this one?

Where is the best place to find "programming" examples for SE?

Thanks a 1,000,000

WB