Continue to Site

Welcome to 3DCADForums

Join our CAD community forums where over 25,000 users interact to solve day to day problems and share ideas. We encourage you to visit, invite you to participate and look forward to your input and opinions. Acrobat 3D, AutoCAD, Catia, Inventor, IronCAD, Creo, Pro/ENGINEER, Solid Edge, SolidWorks, and others.

Is my center points for 37.5 angle arcs are correct?

kingston123

New member
In desired diagram, we can see three arcs with angle 37.5 each but center point for three arcs are not given properly in this sketch. I took center points like this I construct the arc and trim the arc according to desired diagram. So did I done correctly?

My Diagram: base 80 how.JPG

Desired Diagram:desired.jpg
 
What you have done so far is good.

Don't forget to add the 163 height dimension. I don't think the 138 dimension is needed, but you can add it also

But you're still not done yet. The arcs should be tangent to each other.

The sketch will be correct when the lines and arcs become green in color, indicating everything is fully defined.
 
Last edited:

Articles From 3DCAD World

Sponsor

Back
Top