Hi Everyone. I really appreciate this site and all the help everyone offers. I was hoping someone could supply some insight in regards to this. This question is in relation to the Sketching Workbench in Catia
I have seen some sketches in Catia which have tolerances associated to Dimensions. So people have dimensioned a hole and have applied a limit tolerance to it.
Any ideas on how this is done??
Once again I appreciate everyone's insight.
I have seen some sketches in Catia which have tolerances associated to Dimensions. So people have dimensioned a hole and have applied a limit tolerance to it.
Any ideas on how this is done??
Once again I appreciate everyone's insight.