axis selecting problem

[Kiliman Jaro]

when trying to change axis position missing dot for selecting



like on this pic

 

[MrCATIA]

I'm not sure, but what happens if you add a point before you try to move the axis?

(I'm guessing the missing dot indicates there are no points to select)

 

[Kiliman Jaro]

there are 8 points to put axis system on. even on round part vith no points red dot should be there. i'm guessing this is some kind of bug....

 

[Kiliman Jaro]

nope. dot should be there even in round part with no points. it looks like bug to me or some thing you can adjust in settings maybe....

 

[MrCATIA]

There's an active and helpful group of NC programmers over in the COE Discussion Forum. The even have their own forum (MFG) just for CATIA NC discussions.

here's the link: COE : Forums : MFG

I'm sure if you post your question there, someone will be able to tell you about the dot, or verify if it's a bug.