Hello,
I am trying to apply constraints to a countersunk screw.
1- I apply “contact” to the conic surface of the head of the screw and the conic surface of the hole.
Afterwards I wanted to apply “coincidence” to the axis of the screw and the axis of the hole. But I am getting that they are redundant.
2- I don`t know if the right solution can be to apply
- “contact” (like in 1) and “angle” constraint to the planes of the screw, with the planes of the part where the holes are.
- “coincidendce” (like in 1) and “angle” constraint to the planes of the screw, with the planes of the part where the holes are.
Thanks a lot
I am trying to apply constraints to a countersunk screw.
1- I apply “contact” to the conic surface of the head of the screw and the conic surface of the hole.
Afterwards I wanted to apply “coincidence” to the axis of the screw and the axis of the hole. But I am getting that they are redundant.
2- I don`t know if the right solution can be to apply
- “contact” (like in 1) and “angle” constraint to the planes of the screw, with the planes of the part where the holes are.
- “coincidendce” (like in 1) and “angle” constraint to the planes of the screw, with the planes of the part where the holes are.
Thanks a lot