Hello everyone,
I am new to solidworks but I am quickly learning with the help of several youtube videos as I need to use Solidworks in my project.
Actually, I have a drawing. I could not attach the solidwork file because I get the message that this is an invalid file but it's quite like a funnel (according to the jpeg image I have attached).
I need to create a circular array of holes on the slopped part of this funnel-like assembly. I have seen several youtube videos on how to do this. The main solution is to extrude a cut and then try to flatten it and then make the array of holes according to a curve.
The problem is that this method does not work in my case and I am pretty frustrated on how to do it.
Your help, advice and feedback is highly appreciated in this matter,
Kind regards,
Ali
I am new to solidworks but I am quickly learning with the help of several youtube videos as I need to use Solidworks in my project.
Actually, I have a drawing. I could not attach the solidwork file because I get the message that this is an invalid file but it's quite like a funnel (according to the jpeg image I have attached).
I need to create a circular array of holes on the slopped part of this funnel-like assembly. I have seen several youtube videos on how to do this. The main solution is to extrude a cut and then try to flatten it and then make the array of holes according to a curve.
The problem is that this method does not work in my case and I am pretty frustrated on how to do it.
Your help, advice and feedback is highly appreciated in this matter,
Kind regards,
Ali