I have some basic questions concerning Rhino... they're influenced by being primarily a SketchUp user for the past few years...
1) Is there a tool in Rhino similar to tape measure tool in SketchUp? I find this to be the most handy feature of SketchUp am wondering if there is a similar tool or similar method to drawing geometry in Rhino?
2) Does Rhino have a relative coordinates input setting or is 'CPlane' the closest it gets? Its more or less relative but I wonder if there is a way for the software to recognize the direction I am drawing geometry vs always typing in '-'...
Thanks for any insight... I realize such elementary questions may cause one's eye to roll...
1) Is there a tool in Rhino similar to tape measure tool in SketchUp? I find this to be the most handy feature of SketchUp am wondering if there is a similar tool or similar method to drawing geometry in Rhino?
2) Does Rhino have a relative coordinates input setting or is 'CPlane' the closest it gets? Its more or less relative but I wonder if there is a way for the software to recognize the direction I am drawing geometry vs always typing in '-'...
Thanks for any insight... I realize such elementary questions may cause one's eye to roll...